BuiltInFailures.GenericMEPFailures

Public Class

Failures applicable to different mechanical, electrical and piping Elements.

Inheritance Hierarchy

System.Object
Autodesk.Revit.DB.BuiltInFailures.GenericMEPFailures

Assembly: RevitAPI (in RevitAPI.dll) Version: 25.0.0.0 (25.0.0.0)

Syntax

public static class GenericMEPFailures

The BuiltInFailures.GenericMEPFailures type exposes the following members.

Properties

Name

Description

Public Property
Static Member

CapsWereAddedWarning

X caps were added.

Public Property
Static Member

CapWasAddedWarning

1 cap was added.

Public Property
Static Member

FailedToPlaceCapWarning

Failed to place cap on the open connector.

Public Property
Static Member

FlowConfigMismatch

[Element Name]: It is not possible to calculate the flow since all the components in this system have the flow configuration set to Preset or System. At least one component is required to have the flow configuration set to Calculated.

Public Property
Static Member

FlowDirectionMismatch

[Element Name]: It is not possible to calculate the flow since the flow direction mismatch. Please check flow direction on all equipment in this system.

Public Property
Static Member

InlineEndoflineMismatch

[Element Name]: It is not possible to calculate the flow since there is inline equipment that is configured as end of line. Please check equipment in this system and make sure that the equipment connectors used inline have a global system classification and a calculated flow configuration. Global equipment connectors used inline should always be linked to each other.

Public Property
Static Member

MaxWidthAndHeightReached

Maximum width and height reached during sizing

Public Property
Static Member

SegmentIsTooShort

The segment is too short.

Public Property
Static Member

SizingFailedZeroFlow

Sizing failed. Flow for section is 0.

Public Property
Static Member

SplitElementDeletionWarning

The value specified for the Joint Gap exceeds the length of the split segment, so the segment will be deleted.

Public Property
Static Member

ValidatePHSegmentConnWarning

The placeholder curve will not be able to connect to the required fittings for placeholder convert

Public Property
Static Member

ValidatePHSegmentLengthWarning

The placeholder curve is not long enough to support the required fittings for placeholder convert